# Ensure Reverse Path Filtering Is Enabled

- Source: https://support.icompaas.com/support/solutions/articles/62000235321-ensure-reverse-path-filtering-is-enabled
- Section: [Solutions](https://support.icompaas.com/support/solutions) › [CIS Amazon Linux 2 Benchmark v3.0.0](https://support.icompaas.com/support/solutions/62000112696) › [CIS Amazon Linux 2 Benchmarks](https://support.icompaas.com/support/solutions/folders/62000169265)
- Last updated: 2026-05-29
- Publisher: iCompaas, Inc. (https://www.icompaas.com)

**Profile Applicability:** • Level 1

**Description:**  
Reverse path filtering helps prevent IP spoofing by verifying that incoming packets are received on the interface that would be used to send packets back to the source. Enabling this feature helps protect against spoofed traffic and certain types of network attacks.

**Rationale:** Enabling reverse path filtering improves network security by ensuring that packets have valid source addresses and mitigating IP spoofing risks.

**Impact:** Pros:

-   Protects against IP spoofing and certain network attacks.  
    
-   Enhances the integrity of network traffic.  
    

Cons:

-   May cause legitimate asymmetric routing traffic to be dropped in complex network environments.  
    

**Default Value:** Reverse path filtering is often disabled or set to loose mode by default.

**Pre-requisites:**

-   Root or sudo privileges to modify network settings.  
    

**Remediation:**

### **Test Plan:**

**Using Linux command line:**

1\. Check current reverse path filtering settings:  

sysctl net.ipv4.conf.all.rp\_filter  
sysctl net.ipv4.conf.default.rp\_filter

2\. Confirm values are set to 1 (strict) or 2 (loose).

### **Implementation Plan:**

**Using Linux command line:**

1\. Enable reverse path filtering temporarily:  

sysctl -w net.ipv4.conf.all.rp\_filter=1  
sysctl -w net.ipv4.conf.default.rp\_filter=1

2\. Persist the settings by adding to /etc/sysctl.conf or a file in /etc/sysctl.d/:  

net.ipv4.conf.all.rp\_filter = 1  
net.ipv4.conf.default.rp\_filter = 1

### **Backout Plan:**

**Using Linux command line:**

1\. Disable or adjust reverse path filtering if necessary:  

sysctl -w net.ipv4.conf.all.rp\_filter=0  
sysctl -w net.ipv4.conf.default.rp\_filter=0

2\. Update configuration files accordingly and reload sysctl.  

**References:**

-   CIS Amazon Linux 2 Benchmark v3.0.0  
    
-   Linux sysctl Documentation  
    
-   [NIST SP 800-53 Revision 5 - SC-7  
    ](https://csrc.nist.gov/publications/detail/sp/800-53/rev-5/final#sc-7)

## Related compliance guidance

- [SOC 2 compliance: a practical implementation guide for cloud-native SaaS teams](https://support.icompaas.com/compliance/soc-2-trust-services-criteria): Configuration checks like this one are the technical half of a SOC 2 / ISO 27001 programme — the guide shows where they fit, what else an auditor expects, and how to evidence them.
- [ISO/IEC 27001:2022 compliance: a practical implementation guide](https://support.icompaas.com/compliance/iso-27001-2022): ISO 27001 Annex A.8 (technological controls) is where cloud hardening evidence lands; the guide shows how to run the ISMS around it.
